Man I’m getting around a lot here recently. I’m literally living a “Have bonsai, will travel ” lifestyle on the blog.
Today, as I work on a Brazilian Raintree (which you’ll see in the next post or so), I’m at Agresta Gardens, in the studio, assisting Ben (read that, taking pics and nodding my head in support when he waxes poetically about certain bonsai trials and tribulations) in the lowering of a big branch on one of Ed Trout’s signature ficus salicaria. Ben purchased it from Ed about a year ago and has been maintaining it since.You can see my little stick of a Brazilian (which has good movement, in its defense) in the foreground.
Ben had spoken with Ed about lowering the branch, and Ed agreed with the idea. Ben is doing a slight defoliation, just to see the branching better.
That thick branch in the center of the shot, below, is the candidate for lowering.
You can see a guy wire on a secondary branch. That’s part of the technique that’s being used here. It will get a bit more….invasive… in a bit.
First, a screw is drilled into the root base so we have something to attach the bottom of the guy wire to.
On the branch, some aquarium tubing is used, with a split cut into the topside so the wire can be twisted tight (I think that Ben came up with this himself)
Pull it tight…..
Push down on the branch a little, so that when you twist the guy wire during the operation, you have more downward movement, without running out of twisting space.
He’s so delicate sometimes. You should watch him sipping afternoon tea….
With the wire in place, the next step is to mark the cut.
Wait?! The cut? Yes sir and or ma’am or they.
I’m sure you’ve heard of cutting a wedge in a branch to lower it? This technique is similar but instead of a wedge (which is hard to match the angle of the wedge-cut with the ultimate downward movement of a branch, ending up with a bad match of cambium layers, resulting in uneven or no healing at the cut site), we will be cutting a slim blade’s width, and then lowering the branch until it closes, then cut another slice, etc….until the branch is lowered adequately.
First, some Lysol to sanitize the saw. Which is repeated several times during the operation
Then the cut…..
On a ficus, we want to go almost all the way through the branch, only leaving the bark layer on the top, intact
My tree being ignored over there while I assist.
I think Ben performed the slice/twist technique (which is the opposite technique that’s performed by a מוהל) about six times or so. To clarify (thanks Peter) the slice is in the same exact place each time, just removing a blades width of material.
Ben added a second guy wire, which pulled the branch back a little, to get a few more degrees of twist to the pad.
that’s my hand just to show you that I’m just the camera jockey today. I think the regular readers could tell anyway. Look at those nails, who bites them down so short, anyway….ewwww.
And I think he is done. For the record, Bob really is his uncle.
And there’s the end result.
Even though the amount of material taken out at the cut site was less than a quarter of an inch (>6mm) , the movement at the branch tip was probably about four inches (Ben says six. I’m not one to argue. That measurement is best left between him and his wife….)
He didn’t seal the cut site as a ficus “bleeds” it’s own latex, effectively sealing itself (interesting to note, the white latex from a ficus is not its sap, but, depending on whom you listen to, is either a defense mechanism against chewing bugs and animals, or a sealant for when wounds occur and it helps the tree heal faster).
The tree went back into the bench to get some sunshine and to let it grow.
Next post, the friendship BRT.